Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Pasadena Homeowners
A broken garage door spring turns your car into a captive and your garage into a security gap in the time it takes to hear one loud bang. Springs are under extreme tension, so this is not a DIY repair, and it’s not a job for a generalist handyman either. Our technicians have up to 15 years of experience with high-tension torsion and extension systems, and we work on the brands most Pasadena homes already have. If your door is stuck, call (855) 337-1170 and we’ll get you booked. Same-day service is available in Pasadena, and the price is quoted and agreed before any work starts.
What Our Garage Door Spring Repair Service Includes
Every spring repair starts with a real diagnosis, not a guess at the loudest noise in the room. We carry the parts and the winding tools for the spring systems we see across Pasadena, so most repairs get resolved on the first visit. Here’s what each part of the job covers.
Torsion Spring Replacement
The torsion spring is the coiled spring mounted on a metal shaft above the door; it does most of the heavy lifting as the door travels up and down. When it snaps, the door suddenly feels like it weighs a hundred pounds more, because it does. We measure the existing spring’s length, wire size and inside diameter so the replacement matches your door’s actual weight, then wind the new spring to the correct turns and test the door’s balance before we close the job.

Extension Spring Replacement
Extension springs stretch along the horizontal tracks on either side of the door and are the spring setup on many older Pasadena homes. They wear from repeated stretching and can fail without much warning, and a failed extension spring can swing hard when it releases. We replace them in matched pairs so the door lifts evenly, and we check the mounting points and pulleys while we’re in there since those parts take the same load.

Broken Spring Repair
A snapped spring usually makes a sharp bang, and afterward the door either won’t lift at all or lifts a few inches and stops. We confirm the break, check that nothing else was damaged when the spring let go, and replace the failed part. If the door dropped when the spring broke, we also inspect the tracks and the bottom section, because that’s where secondary damage shows up.

Spring Adjustment
Sometimes the spring isn’t broken, just out of balance – the door feels heavy, slams down, or reverses before it reaches the floor. An unbalanced door strains the opener and the springs, so the fix is often an adjustment rather than a replacement. We set the tension to the door’s actual weight and confirm the door stays put when you let go halfway up.
Safety Cable Installation
Safety cables run through the center of each extension spring and are the containment line if the spring ever breaks. Homes with extension springs should have them, and a missing or damaged cable is one of the simplest safety upgrades we make. We install them so a failed spring stays contained instead of flying loose.
Spring Inspection
A spring that’s nearing the end of its life usually shows it: gaps in the coil, a stretched extension spring, rust at the winding cone, or a door that’s getting harder to lift. A spring inspection checks all of that along with the cables, drums and center bearing. It’s the cheapest way to catch a failure before it happens at a bad moment.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
We work on Raynor systems regularly, including their extension and torsion setups, and we know the points where the hardware on those doors tends to wear before anything else. We also service LiftMaster equipment, and since LiftMaster openers work hand in hand with the door’s spring tension, we can trace a “weak opener” back to the real cause when the spring is the problem. Chamberlain systems get the same treatment, and we look at both the mechanical side and the connected side of the opener because those doors carry their own tension load.
Genie doors and openers round out the mix we see most often in the Pasadena area, and we’re familiar with how those systems respond when a spring has lost tension. Whether you have Raynor, LiftMaster, Chamberlain, Genie or any other make, we can help – the spring doesn’t care whose name is on the door, but knowing the system means we bring the right parts and get it right the first time.
Signs You Need Garage Door Spring Repair Right Now
- A loud bang from the garage. That sound is usually a torsion spring breaking, and the door won’t open afterward. Stop using the opener – pulling on a door with a dead spring strains the opener and can bend the door panels.
- The door feels extremely heavy when you lift it. A properly balanced door lifts with one hand and stays halfway up on its own. If it slams down or won’t stay put, the tension is wrong or the spring is failing.
- A visible gap in the coil. A gap of an inch or two in a torsion spring means it has broken at that point. It’s not a cosmetic issue; the spring can’t carry the door’s weight in that condition.
- The door opens a few inches and stops. This often points to a broken spring, though it can also be an opener issue. Either way, don’t keep cycling the door – the motor is working against weight it wasn’t built to lift.
- Rust, sagging or a stretched extension spring. Rust at the winding cone and sagging extension springs both shorten the life of the part. Catching them early is cheaper than a same-day call after they let go.
Our Garage Door Spring Repair Process – Step by Step
- 1
We take the call and ask the right questions. We’ll ask what the door is doing, which brand it is, and whether the door is up or down. That tells us what to expect before we arrive and helps us come prepared for the right kind of spring.
- 2
We inspect before we touch anything. Springs, cables, drums, and the door’s balance get checked as a system. A problem that looks like a spring may actually involve a worn cable or a bent track, and we’d rather find it now than after the invoice.
- 3
We quote the price and get your agreement. You get a clear, written estimate before any work begins, and the written quote sets the final price. If the inspection turns up something extra, we tell you before we touch it, not after.
- 4
We do the repair with the right tools. Winding a torsion spring takes a proper winding bar and a trained hand – no ladder-and-pry-bar work. We replace springs in matched pairs when both are the same age, then test the door’s travel and balance.
- 5
We test the door and walk you through it. The door should open and close smoothly, reverse correctly, and stay balanced halfway up. We show you what we replaced and what to watch for going forward.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Pasadena?
Spring repair in Pasadena typically runs $180 – $340 for one spring. That range covers the common cases: a single torsion spring replacement, an extension spring replacement, or a broken spring repair with the door rebalanced afterward. Because a matched pair is usually replaced together, a pair costs about twice that range – and on a two-spring door, replacing both at once is usually the smarter call since the second spring is typically the same age as the one that just failed.
What moves the price within that range: the type of spring, how many springs need replacing, and whether anything else was damaged when the spring let go. A door that dropped can need track or cable work, and we quote that separately after the inspection. Nothing gets added to the bill without your agreement first.
- Spring repair (one spring): $180 – $340
- Matched pair: about twice the single-spring range
- Cable repair, if needed: $130 – $250
- Track realignment, if the door dropped: $120 – $240
- Opener repair, if the motor was strained: $120 – $320
Every estimate is free, and we quote the price before any work starts. Call (855) 337-1170 for an exact quote on your door.
Garage Door Spring Repair Near Pasadena – Our Service Area
We take spring repair calls across Pasadena and the surrounding communities, including Deer Park, South Houston, La Porte, Galena Park, Jacinto City, Cloverleaf, Webster, Nassau Bay, El Lago, Taylor Lake Village and Shoreacres. If your door is stuck, call us and we’ll confirm availability and the soonest appointment for your address. You can also read more about our Pasadena Garage Door Repair Co services, or check our garage door spring repair page for Deer Park and our garage door spring repair page for South Houston.
Serving Pasadena, TX – Our Local Coverage Area
We serve Pasadena and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Pasadena
Garage door spring repair is the replacement or adjustment of the torsion or extension springs that counterbalance your door’s weight. The springs do most of the lifting so the opener only has to guide the door, and when they fail the door becomes dangerously heavy. It’s a safety-critical repair, and it requires the right winding tools and training rather than a ladder and a video.
Most single-spring repairs are finished within a couple of hours once we’re on site, and many are same-day. A matched pair takes a little longer because both springs get wound and the door gets rebalanced afterward. If the door dropped when the spring broke and the tracks need attention, plan for a bit more time – we’ll tell you what we expect before we start.
Spring repair in Pasadena typically costs $180 – $340 for one spring, and a matched pair runs about twice that since both springs are usually replaced together. The final number depends on the spring type and whether anything else was damaged when it broke. We quote the price and get your agreement before any work starts. Call (855) 337-1170 for an exact quote – estimates are free.
Yes. We’re equipped to service LiftMaster, Chamberlain, Genie and Raynor systems, along with Clopay, Amarr, Wayne Dalton and Craftsman. Knowing the brand helps us diagnose faster, especially when an opener problem turns out to be a spring tension issue. Tell us the brand when you call and we’ll come prepared.
Same-day service is available in Pasadena, so call (855) 337-1170 and we’ll confirm the soonest appointment for your address. A broken spring leaves the door unsafe to operate, so don’t keep running the opener while you wait. If the door is stuck open, we treat it as a security issue and prioritize it accordingly.
We stand behind the work we do, and we’ll go over the warranty terms on the parts and labor with you when we give you the estimate, so you know exactly what’s covered before you agree to anything. If something isn’t right after the repair, call us and we’ll come back out to look at it. The written estimate lays out the terms in plain language.
Clear the area under and around the door so there’s room to work, and if you can, move the car out of the garage. Leave the door in whatever position it’s in – don’t try to force it open or closed. Have the brand name and model of your door or opener handy if you know it, and tell us when you call whether the door is up or down.
Schedule Your Garage Door Spring Repair Service in Pasadena Today
A broken spring won’t fix itself, and every cycle on a dead spring puts more strain on your opener and your door. Call (855) 337-1170 to schedule spring repair in Pasadena. We’ll give you a free estimate, quote the price before any work starts, and get your door back up and running. Emergency or planned, we cover it.
Written by the team at Pasadena Garage Door Repair Co.